TURBINA FICTICIA CON ELECTRONICA

Dummy turbines produce an amazingly realistic visual effect. The dummy turbine pipes are based on the original design, and project out of the fuselage on both sides.

Inside the moulded GRP dummy turbine (supplied in the set) an electronic circuit board is installed, fitted with light-emitting diodes. When the pilot operates the switch on the RC system transmitter, the interior of the jet efflux lights up and looks just like a turbine starting up.

After about five seconds the dummy looks almost indistinguishable from a turbine which is actually running. When the simulated turbine is switched off at the transmitter, the dummy engine appears to run down slowly.
The system utilises ultra-bright LEDs to ensure that the effect can be seen clearly even in daylight.

• Dummy turbine with electronics
• two sets required
• electrical ring: Ø 50mm
• Plastic part length 150mm, Ø 55 mm
• Only for Vario Turbine Airwolf, Ord.No. 2004