Atención al cliente (34) 971 554 642 - (34) 971 909 797

TARJETA PROGRAMADORA HS MAYTECH

TARJETA PROGRAMADORA HS MAYTECH
TARJETA PROGRAMADORA HS MAYTECH
TARJETA PROGRAMADORA HS MAYTECH

MAYPROGCARDHS

Tarjeta programadora de Maytech para variadores serie MT v1 y MTE

Estado: NUEVOPRODUCTO/S EN STOCK Entrega 24/48 h (salvo indicado en DESCRIPCION-Baterias y sprays minimo 48H)
10,90
21.00% IVA incluido
unidades

Añadir a cesta

Nota: no usar una fuente de más de 6V para programar el variador.

Especificaciones:

Net Weight ……………………………………6.5g

Size……………………………………………. 49(L) x30 (W)mm

 Operation

  1. A) When you are using an ESC with a built-in BEC (Battery Elimination Circuit)

1). Disconnect the main power pack from the ESC

2) Plug JR connector (part of ESC) to the position “P” on Prog-Card (Refer to the pic as below).

3) Put the seven blue jumper connectors to the position (parameter) you selected.

4) Connect the power pack to the ESC; One long “beep” will be heard, which means your setting has been saved.

5) Re-disconnect the main power pack to the ESC, the setup will be saved!

 

  1. B) When you are using an ESC without a built-in BEC

If the ESC is marked with “BEC OPTO”, that means this ESC hasn’t a built-in BEC, so you must use an additional battery pack (4.8-6V) to power the program card, and usually a receiver battery pack is a good choice. By the way, every high voltage ESC (Supports 5-12 cells Lipo battery) hasn’t built-in BEC.

1) Disconnect the main power pack from the ESC

2) Connect the receiver battery pack (4.8-6V) to the program card at the top right corner position. (Refer to the pic as below)

3) Plug JR connector (part of ESC) to the position “P” on Prog-Card (Refer to the pic as below).

4) Put the seven blue jumper connectors to the position (parameter) you selected.

5) Connect the power pack to the ESC; One long “beep” will be heard, which means your setting has been saved.

6) Re-disconnect the main power pack to the ESC, the setup will be saved!

 

NOTE: Don’t use a battery pack higher than 6V to supply the program card!

Marca

MAYTECH

Familias relacionadas

Accesorios RC Equipos RC Varios

Fecha de lanzamiento

Martes, 14 Junio 2016